Rockers

Hello,

I have made my new bearing blocks, it was (for me as a layman) very time consuming, but I think it was worth it.
Maybe the drawing is useful for someone who has the same problem.
I would like to point out that the dimensions are perhaps not 100% the original, but the distances of the axle bearings and the mounting holes should be correct.
In any case they fit on my engine and she has already run with it.
I have machined the shafts so that they are without running tracks, accordingly I have adapted the guide bushings.

Greeting

Wolfgang

Translated with www.DeepL.com/Translator (free version)

The material for the bearing block is AW 775
GBZ 12 for the bearing bushes

Superb, Wolfgang, superb!
I've looked at Aluminium Warehouse's stock: a piece of high-grade plate 25 mm. x 100 mm. x 100 mm. would cost £6.50, but beware, Customers' Comments of this supplier are about the most poisonous I've ever read!
Below I've set a few pictures of my Inglis rockers, very similar in appearance to Wolfgang's.

We have made new Inglis bodies

Peter,
They look excellent. Is there a set available?
best wishes
Ian

Hello Peter

I would also be interested in a set if there are enough to go around. Please add me to the list.

Thanks

Phil